M|Flux:5 Fume Extractor


The M|Flux:5 Fume Extractor from Laguna is designed to provide air filtration for laser machines. The intake on top of the unit offers 4 x 4” inlets with a central 6” inlet. Any combination of inlet – 1×4”, 2×4”, 3×4”, 4×4”, 1×6”- can be used with this unique design. Materials such as acrylic and wood emit noxious fumes when cut or engraved by the laser machine. These fumes are harmful to our lungs, as well as harmful to the machine, and should be filtered or drawn away from the machine. This fume collector allows you to efficiently filter out these fumes and fine debris from the air.


  • Motor Specs: 1 HP
  • Electrical Specs: 110V / 60Hz / 1PH
  • Running AMP (with 6” inlet) 7A at 110V
  • Air Volume: 313CFM (cubic feet per minute)
  • Fan size 9”
SKU: MDCMFLUX52201 Category:

M|Flux:5 Fume Extractor

Machine Specs

Motor Specs: 1 HP

Electrical Specs: 100V / 60Hz / 1PH

Running AMP (With 6″ Inlet): 7A at 110V

Air Volume: 313CFM (Cubic Feet Per Minute)

Fan Size: 9″

Inlet 6″ and Optional 4″ x 4 ports covered with steel plates

Switch Control: Panel Switch

Packin Size (L x W x H): 40.2″ x 19.3″ x 21.5″ (102 x 49 x 54.5cm)

Machine Weight: 128 lbs (58 kgs)

Shipping Weight: 139 lbs (63 kgs)

Filters are easily replaced by unlocking the compartment, lifting it off, and inserting the cartridge.

The unit is equipped with swivel casters, the two front casters have built-in brakes.

Filter Media

HEPA Filter
  • Pleated panel type high efficiency particulate are filter. 330 x 330 x 100mm x 2 pcs
  • Installation in top module and bottom module
  • Filter Efficiency: 99.99% @ 0.3 micron
Adsorption Filter (Course)
  • Activated Carbon M3000
  • 330 x 330 x 50mm
  • To remove odors/smoke via chemical adsorption
Adsorption Filter (Fine)
  • Activated Carbon M9000
  • 330 x 330 x 50mm
  • To remove odors/smoke via chemical adsorption.

The HEPA filter offers 99.99% filtration efficiency of> 0.3 micron.

Two different kinds of Charcoal filter are utilized: the M3000 (2”) mitigates fumes by physical absorption, the M9000 (2”) mitigates fumes by chemical reaction.

Below the filters sit a 1HP 110 volt TEFC motor and fan that supplies 400CFM and high static pressure to pull the air through the filters.

HEPA filters are approximately 13” x 13” x 4″

Carbon filters are approximately 13” x 13” x 2″

M|Flux:5 Manual

Where To Buy




There are no reviews yet.

Be the first to review “M|Flux:5 Fume Extractor”

Your email address will not be published. Required fields are marked *